Converter board
The converter board is located on the left side of the computer (viewed from behind) under the main rear
cover. It is secured with two Torx screws and has two connectors.
Use the same converter spare part for all display panels; however, you must change jumper settings on the
board based on the display panel.
To remove the converter board:
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
Disconnect the two cables from the board (1).
NOTE:
the wires.
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
Be careful not to damage the cables when disconnecting them from the board. Do not pull on
Preparing to disassemble the computer on page
31).
32).
37).
31).
Converter board
43