Converter Board - HP ProOne 400 G1 Maintenance & Service Manual

Converter board

Description
Converter board
The converter board is located on the left side of the computer (viewed from behind) under the main
rear cover, below the touch sensor board. It is secured with two Torx screws and has two connectors.
Use the same converter spare part for all display panels; however, you must change jumper settings on
the board based on the display panel.
To remove the converter board:
1.
Prepare the computer for disassembly (see
2.
Remove the rear cover (see
3. Disconnect the two cables from the board (1).
NOTE:
cable straight out of the connector at a vertical (90°) angle.
Rear cover on page
To avoid damaging the connector when disconnecting the cable, be sure to pull the
Preparing to disassemble the computer on page
34).
Spare part number
763205-001
31).
Converter board
59