System Board - HP EliteOne 705 G2 Maintenance & Service Manual

System board

The system board is secured with a a total of ten Torx screws. Two of the screws also secure the removable
side bracket, and two other screws secure the I/O bracket.
To remove the system board:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the system board shield (see
6. Remove the memory modules (see
7. Remove the mSATA drive (see
8. Remove the WLAN module (see
9. Remove the heat sink (see
10. Remove the processor (see
on page
11. Disconnect all cables from the system board, noting their location for reinstallation.
12. Remove the side bracket by removing the two Torx screws (1), and then rotate the bracket to remove it.
13. Remove the rear I/O port cover by removing the two Torx screws (2), and then rotate the bracket to
remove it.
64 Chapter 4 Removal and Replacement Procedures
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
PCI-Express M.2 Solid-State Drive on page
WLAN module on page
Heat sink on page
Processor – AMD models on page
62.
Preparing to disassemble the computer on page
31).
37).
System board (EMI) shield on page
Memory on page 49).
56).
59).
32).
48).
54).
61) or Processor – Intel models
31).