Adjustable-Height Stand; Attaching An Adjustable-Height Stand; Removing An Adjustable-Height Stand - HP EliteOne 705 G2 Maintenance & Service Manual

Adjustable-height stand

Attaching an adjustable-height stand

To install the stand:
1. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket, towel,
or other soft cloth to protect the bezel and screen surface from scratches or other damage.
2. Engage the hooks in the top of the stand in the two large holes in the upper part of the back of the
computer (1).
3. Lower the stand onto the computer (2) and press down until it clicks into place (3).

Removing an adjustable-height stand

To remove the stand:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Press the release latch under the stand (1).
4. Lift the stand up (2), and then pull the stand hooks out of the computer (3).
34 Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page 31).
31).