Display Panel - HP EliteOne 705 G2 Maintenance & Service Manual

Display panel

IMPORTANT:
any old parts. Return all old parts to HP for warranty processing.
CAUTION: it is very important to use the exact cable that shipped with the replacement panel. Failure to use
the correct cable may result in panel failure.
IMPORTANT:
touch sensor board when replacing a touch display panel. You must install the latest touch drivers. Failure to
install the latest drivers could result in a loss of touch functionality. Go to
latest drivers.
To remove the display panel:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the optical drive (see
6. Remove the system board shield (see
7. Remove the speakers (see
8. Remove the top trim (see
9. Remove the right trim (see
10. Remove the left trim (see
11. Remove the bottom trim (see
12. Remove the webcam screws (1) and disconnect and remove the webcam.
13. Disconnect the backlight cable from the display panel (2).
14. Remove the 10 Torx screws (3) that secure the main frame to the display panel.
15. When separating the panel from the frame, route the main display cable through the hole in the frame
(4).
Install the new display panel together with all other parts in the replacement kit. Do not reuse
Touch sensor boards are spared with the touch panel spare part kit. Be sure to replace the
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
Optical drive on page
Speakers on page
Top trim on page
Right trim and fingerprint reader on page
Left trim on page
Bottom trim and feet on page
Preparing to disassemble the computer on page
31).
37).
41).
System board (EMI) shield on page
74).
45).
82).
83).
www.hp.com/support
32).
48).
80).
Display panel
to install the
31).
85