Serial/PS2 board
The serial/PS2 board is located to the left of the center rear I/O panel. It is secured with two screws and has
one connected cable.
NOTE:
HP ProOne 600 models also include a hood sensor on the serial port/PS2 board.
To remove the serial/PS2 board:
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
Remove the system board shield (see
6.
Remove the I/O bracket secured to the system board (see callout 2 in
7.
Remove the rear I/O panel (see
8.
Disconnect the cable (1) from the board.
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
System board (EMI) shield on page
Center rear I/O panel on page
31).
32).
37).
48).
System board on page
73).
31).
64).
Serial/PS2 board
71