Converter Board - HP 205 G1 Maintenance & Service Manual

Converter board

Description
Converter board
The converter board is located on the left side of the computer (viewed from behind) under the main rear
cover. It is secured with two Torx screws and has two connectors.
Use the same converter spare part for all display panels; however, you must change jumper settings on the
board based on the display panel.
To remove the converter board:
1. Prepare the computer for disassembly (see
2. Remove the rear cover (see
3. Disconnect the two cables from the board (1).
NOTE:
the wires.
4. Remove the black Torx screw (2) that secures the board to the computer.
30 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis
Rear cover on page
Be careful not to damage the cables when disconnecting them from the board. Do not pull on
Preparing to disassemble the computer on page
20).
Spare part number
751276-001
19).