Center Rear I/O Panel - HP EliteOne 705 G2 Maintenance & Service Manual

Center rear I/O panel

The center rear I/O panel is located below the stand on the bottom rear of the computer. It is secured with two
screws. You must remove the serial/PS2 board to remove the center rear I/O panel.
To remove the center rear I/O panel:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the rear port cover (see
4. Remove the stand (see
5. Remove the access panel (see
6. Remove the serial/PS2 board (see
7. Remove the system board shield (see
8. Remove the I/O bracket secured to the system board (see callout 2 in
9. Remove the two screws (1) that secure the rear I/O panel to the computer, and then pull the panel away
from the serial/PS2 board to detach it from the chassis (2).
NOTE:
may have to maneuver the panel until it comes loose. Be careful not to break the plastic on the panel
when trying to remove it.
To replace the center rear I/O panel, reverse the removal procedures.
The rear I/O port cover must be replaced to replace the center rear I/O panel. Callout 2 in the system board
removal image (see
is shown in the following image.
Access panel on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
The rear I/O panel may bind and hang up around the connectors on the serial/PS2 board. You
System board on page
Preparing to disassemble the computer on page
37).
31).
37).
Serial/PS2 board on page
System board (EMI) shield on page
64) shows removing the rear I/O port cover. The rear I/O port cover
32).
71).
48).
System board on page
Center rear I/O panel
31).
64).
73