Memory - HP EliteOne 705 G2 Maintenance & Service Manual

Memory

Description
8-GB
4-GB
2-GB
The computer comes with small outline dual inline memory modules (SODIMMs).
The memory sockets on the system board can be populated with up to two industry-standard SODIMMs.
These memory sockets are populated with at least one preinstalled SODIMM.
For proper system operation, the SODIMMs must meet the following qualifications:
SODIMM
Compliance
Pins
Support
Slots
Maximum Memory
Supported
Note
HP offers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.
The system will automatically operate in single channel mode, dual channel mode, or flex mode, depending
on how the SODIMMs are installed. Refer to the following table to identify the SODIMM channel locations.
Location
Lower Socket
Upper Socket
EliteOne 800 and ProOne 600
1.2 volt DDR4-SDRAM SODIs
unbuffered non-ECC PC4-10600 DDR4-2133 MHz-
compliant
industry-standard 260 pin containing the
mandatory Joint Electronic Device Engineering
Council (JEDEC) specification
support CAS latency 11 DDR4 2133 MHz (11-11-11
timing)
2
32 GB
1 Gbit, 2 Gbit, and 4 Gbit non-ECC memory technologies single-sided and double-sided SODIMMs
The system will not operate properly if you install unsupported SODIMM memory. SODIMMs constructed
with x8 and x16 SDRAMs are supported; SODIMMs constructed with x4 SDRAMS are not supported.
System board label
SODIMM1
SODIMM3
EliteOne 705
1.5 volt DDR3-SDRAM SODIs
unbuffered non-ECC PC3-10600 DDR3-1600 MHz-
compliant
industry-standard 204 pin containing the
mandatory Joint Electronic Device Engineering
Council (JEDEC) specification
support CAS latency 11 DDR3 1600 MHz (11-11-11
timing)
2
16 GB
Channel
Channel B
Channel A
Memory 49