System Board (Emi) Shield - HP EliteOne 705 G2 Maintenance & Service Manual

System board (EMI) shield

The system board shield covers the system board. A latch holds the shield in place.
To remove the system board shield:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Push the EMI shield latch toward the center of the computer (1) to release the EMI shield, and then lift
the shield off the computer (2).
To install the system board shield, reverse the removal procedures.
48 Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
31).
32).
37).
31).