Right trim and fingerprint reader
The right trim can include an integrated fingerprint reader. One cable connects to the fingerprint reader, and
six Torx screws secure the trim. Two of the screws are located under a plastic piece at the mouth of the optical
drive on models so equipped.
To remove the right trim:
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
If installed, remove the optical drive (see
6.
Remove the top trim (see
7.
If installed, disconnect the fingerprint reader cable from the system board and remove the cable from
the routing path near the bottom of the computer.
80
Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
Optical drive on page
Top trim on page
45).
31).
32).
37).
41).
31).