Speakers
The speakers are located at the bottom of the computer. Two separate speakers are each secured by two Torx
screws.
To remove the speakers:
1.
Prepare the computer for disassembly (see
2.
Remove the rear port cover (see
3.
Remove the stand (see
4.
Remove the access panel (see
5.
Remove the system board shield (see
6.
Remove the I/O bracket secured to the system board (see callout 2 in
7.
Remove the rear I/O panel (see
8.
Disconnect the speaker cable from the system board (1).
9.
Remove two Torx screws (2) that secure each speaker to the computer.
10.
Remove speaker cable from the clips and routing path built into the chassis (3).
11.
Remove the speakers from the computer.
To install the speakers, reverse the removal procedures.
When installing the speakers, make sure the rubber grommets are correctly installed in the speakers.
74
Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
System board (EMI) shield on page
Center rear I/O panel on page
31).
32).
37).
48).
System board on page
73).
31).
64).