Fuji Xerox DocuCentre-III 2007 Administrator's Manual page 444

15 Appendix
Extended Settings
Setting Item
Paper position
Output quantity
Reduce/enlarge
2 Up mode
15
442
Item
Number
20 Sets the paper position.
[0] (Default)
[1]
Note •When a continuous form paper is selected for [Document Size],
8 Sets the number of copies to be printed.
[1 to 250] (Default: 1): 1-250 copies
Important •When the output quantity is specified by a client, the copies of that set
54 Sets the print magnification.
(Reduce/ [0] (Default)
enlarge mode) [1]
[2]
[Preset %] is a magnification calculated automatically based on
[
Document
area of the original to fit to the printable area of the output paper.
Therefore, if the size of the original and that of the output paper are the
same, the magnification will be 100%. Also, if [2 Up] is selected, the
original will be reduced to the size where two pages fit into one sheet of
paper.
[Variable %] is a magnification set in [Variable %] under [Reduce/
Enlarge]. A reference point for scaling (reducing/enlarging) is the upper
left corner of the printable area. This reference point applies to all text,
images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area to the printable area of
the output paper. It is a magnification calculated automatically based on
[
Document
original (including the area outside of the printable area) to fit to the
printable area of the output paper.
17 Sets the magnification for the vertical or horizontal direction.
(Variable %/ [45 to 210] (Default:100): 45-210%
vertical
Note •When a continuous form paper is selected for [Document Size], both
magnification)
18
(Variable %/
horizontal
magnification)
21 Sets whether to print in 2 Up or page by page. 2 Up is a feature that
prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the
other.
[0] (Default)
[1]
[2]
Important •When [Landscape] is selected for [Document Size], [Forward] or
Value
: Without cut sheet feeder (left)
: With cut sheet feeder (center)
[Paper Position] cannot be set.
of number will be printed. After printing, the number set on the
control panel will be changed to that number. However, the number
of copies specified from NetWare or lpd port will not change the
number set on the control panel.
: Preset %
: Variable %
: Fit to Cut Sheet
Size] and [Paper Size], and reduces/enlarges the printable
Size] and [Paper Size], and reduces/enlarges the whole
[Preset %] and [Fit to Cut Sheet] produce the same print result.
: Off
: Forward
: Reverse
[Reverse] produce the same print result.