Fuji Xerox DocuCentre-III 2007 Administrator's Manual page 341

Category
Error Code
C P F S M O
003-753
003-754
003-755
003-756 O
003-757
003-760
O O
003-761
O O
003-764
O
003-780 O
003-795 O
003-981
O
005-210 O
005-275
O
005-280
005-283
005-284
005-285
005-286
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
O [Cause] The mixed sized document was to be scanned with high
resolution using the 2-sided feature.
[Remedy] Set [Resolution] to [200dpi], and try again.
O [Cause] An error occurred in the document feeder.
[Remedy] Execute the job again.
[Cause] The fax document is all blank.
[Remedy] Check whether or not the document is blank or the
document is correctly loaded.
O [Cause] The mixed sized document was to be scanned with high
resolution using the 2-sided feature.
[Remedy] Set [Resolution] to [300dpi] or lower, and try again.
[Cause] An incompatible combination of features are specified as
document scan conditions.
[Remedy] Check the selected options.
[Cause] The paper size of the tray selected for auto tray is different
from the paper size of the tray selected for Auto Tray
Switching.
[Remedy] Change the paper size for the tray, or change the [Paper
Type Priority] settings.
[Cause] The scanned documents contains only one page for form
overlay function.
[Remedy] Make sure the document contains at least two pages.
[Cause] Failed to compress the scanned document.
[Remedy] Reduce the resolution or the ratio for [Reduce/Enlarge] to
decrease the data size, or split the data to send it
separately.
[Cause] When enlarging/reducing a scanned document to the
specified paper size, the reduction/enlargement ratio value
is out of allowed range.
[Remedy] Take one of the following actions:
Manually enter a reduction/enlargement ratio.
Change the paper size.
[Cause] For a mixed size document, the stapling feature is
available for paper with the same width.
[Remedy] Cancel stapling or align the paper width for stapling.
O [Cause] The document feeder settings failed.
[Remedy] Turn the machine off and on, then perform the same
operation again.
O O [Cause] An error occurred in the document feeder.
[Remedy] Turn the machine off and on. If the error persists, contact
our Customer Support Center.
Cause and Remedy
Error Code
14
339