Attaching And Removing Presser Feet; Attaching And Removing Shank - ELNA eXcellence 720 Instruction Manual

Attaching and Removing Presser Feet

Press the "Up/Down Needle" key until the needle
is in the raised position.
Turn OFF the power switch. Raise the presser foot
and press the red button q on back of the shank.
The presser foot will drop off.
q
e
w
Place the selected presser foot so the pin e on
the foot lies just under the groove w of the shank.
Lower the presser bar and attach the foot.

Attaching and Removing Shank

Turn OFF the power switch. Raise the presser
bar.
w
q
e
Turn the thumbscrew q counterclockwise with the
screwdriver to remove the shank.
To attach, loosen the thumbscrew q counterclockwise
with the screwdriver. Attach the presser foot w to the
presser bar e. Tighten the thumbscrew by turning it
clockwise.
30