Table of Contents
Advertisement
e
w
q
e
q
e
e
w
q
w
w
r
10
Presser Foot Lifter
The presser foot lifter raises and lowers the
presser foot.
You can raise it about 1/4˝ (0.6 cm) higher than
the normal up position for easy removal of the
presser foot, or to help you place heavy fabric
under the foot.
q Lowered position
w Normal up position
e Highest position
Changing the Presser Foot
CAUTION:
Turn OFF the power switch before changing the
foot. Always use the proper foot for the selected
pattern. The wrong foot can cause the needle to
break. Do not push the lever down to prevent it
from being broken.
To remove:
Raise the needle to its highest position by turning
the handwheel counterclockwise. Raise the
presser foot, and press the lever on the back of
the foot holder.
q Lever
To attach:
Place the desired presser foot, so that the pin
on the foot lies just under the groove on the foot
holder. Lower the presser foot lifter to lock the foot
in place.
w Pin
e Groove
Removing and Attaching the Presser Foot
Holder
CAUTION:
Turn OFF the power switch before detaching or
attaching the presser foot holder.
To remove:
Remove the setscrew by turning it
counterclockwise with a screwdriver and remove
the presser foot holder from the presser bar.
To attach:
Match the hole in the presser foot holder with the
threaded hole in the presser bar. Fit the setscrew
into the hole. Tighten the screw by turning it
clockwise with a screwdriver.
q Setscrew
w Presser foot holder
e Hole
r Threaded hole
Advertisement
Table of Contents
