Attaching And Removing Presser Feet; Attaching And Removing Shank; Seam Allowance Lines; Centimeter/Inch Quick Measurements - ELNA 7200 Instruction Manual

Attaching and Removing Presser Feet

Press the "Up/Down Needle" key until the needle
is in the raised position.
Turn OFF the power switch. Raise the presser foot
and press the red button q on back of the shank.
The presser foot will drop off.
q
e
w Place the selected presser foot so the pin e on
the foot lies just under the groove w of the shank.
Lower the presser bar and attach the foot.

Attaching and Removing Shank

Turn OFF the power switch. Raise the presser
bar.
q
Turn the thumbscrew q counterclockwise with the
screwdriver to remove the shank.
To attach, match the hole in the shank w with the
w
hole in the presser bar e. Put thumbscrew in hole
e
and turn clockwise to tighten.

Seam Allowance Lines

q
The lines on the needle plate and bobbin cover plate
e
help you measure seam width.
The numbers indicate the distance (in millimeters
and inches) between the center needle position 3.5
q and the seam allowance line w. Use the seam
allowance line as a guide for the fabric edge e.
w

Centimeter/Inch Quick Measurements

Use this handy tool located on the machine base
for quick measurements.
17