Attaching and Removing Presser Feet
Press the "Up/down Needle" key until the needle is in the
raised position.
Turn OFF the power switch. Raise the presser foot and
press the red button q on back of the shank. The
e
presser foot will drop off.
w
Place the selected presser foot so the pin e on the foot
q
lies just under the groove w of the shank. Lower the
presser bar and attach the foot.
Attaching and Removing Shank
Turn OFF the power switch. Raise the presser bar.
Turn the thumbscrew q counterclockwise with the
screwdriver. Pivot shank towards rear and remove the
shank.
To attach, from the rear of the presser bar pivot shank
opening around presser bar and turn thumbscrew
clockwise to tighten.
q
Seam Allowance Lines
The lines on the needle plate, free arm and bobbin cover
q
plate help you measure seam width.
e
The numbers indicate the distance (in millimeters and
inches) between the center needle position 3.5 q and
the seam allowance line w. Use the seam allowance line
as a guide for the fabric edge e.
w
11