Table of Contents
Advertisement
the rod.
the crankshaft.
Piston and Rod Removal
Check
COI1n,~ctiInQ
rod side clearance.
If clearance exceeds the service limit,
Recheck and if still out of limit,
Inspe,:t the crankshaft for
spots or da/llage.
COl'lnl:lctil'lg Rod Side Clearance:
Standard:
0.15 - 0.30
mm
(0.006 - 0.012
in)
Service limit
0.40
mm
6
in)
Remove the left side rods and
Mark them to indicate
the correct
2 and 4) and
on the
NOTE: The left
side
rod
hA,~rir,n
inserts are drilled and
with the rod oil holes to
lubrication to the cylin<:ler
walls.
Remove the
side rods and
Mark them to
indicate the correct
(No.1 and 3) and
on
the
cralnkp'lns.
CAUTION: On
with high mileage, inspect the
cylindiers for a ridge
above the highest point of ring
travel. Any ridge must be removed with an automotive type
ridge reamer before removing the right side
to
allow the pistons and
to pass through the cylinder.
side rod inserts are not drilled. Normal
lubrication to the
side
~/
CYLINDER WEAR
RIDGE
8-9
Advertisement
Table of Contents
Troubleshooting
