Table of Contents
Advertisement
Fit the final drive case
into the driveshaft end and
install the gear case nuts.
Lower the brake
'1\">1''''''' a
flat screwdriver tip into the
bolt slot and
Il1stall the axle. Turn the axle and check that it rotateS
then hand
the axle nut.
the gear case nuts to 40 N·m
the axle nut and install a new cotter pin.
90 N'm (66 ft·lb)
95 N'm (69
Remove the
from the
bolt slot and screwdriver
from the hole in the axle.
REAR AXLE NUT TORQUE
1980-1982:
1983- :
Hold a screwdriver
axle to
it from
Install and torque the
bolt to 26 N·m (19
Install and torque the shock absorber nut and bolt to 35 N·m
14.. 13
Advertisement
Table of Contents
Troubleshooting
