On-Board Air Compressor System; Air Pump Filter Element Cleaning; Air Drier Inspection And Service - Honda GoldWing GL1100 Service Manual

the top compartment cover and remove the air pump
WARNING: Never use or low flash
solvents for the element. A fire or could
result.
Wash the element in clean non-flammable cle'aning solvent
and allow to
filter.
Seiparate the filter hou!llina and remove the element.
Maintenance
Air ompressor System - - - - - - - - - - - - - - -
Ele,m4:mt Cleaning
the cap onto
Soak the element in clean gear oil
squeeze out the excess.
Reinstall the element in the and
the until it snaps closed.
80
or and
_ DRY_
WASH IN SQUEllE OUT
SOLVENT SOLVENT
THOROUGHLY
GEAR Oil SQUEEZE OUT
(SAE 80 - 901 EXCESS Oil
Air Drier Inspection and Service
If the desiccant is colorless, disconnect the air hoses and
remove the air drier.
Remove the drier and the desiccant coior in the
window. The desiccant should be biue.
the top compartment cover and
off the drier cover.
DESICCANT
Close the top compartment cover.
Remove the other pa(;Klllgs and retainer
®
RETAINER PLATE
~'CCANT
/ PACKING
P /
SPRING
PACKING
;I
I
CAP
J?
RETAINER PLATE
i),~4t~
SPRING
SEAT~~
t
COVER SCREW
12 -45),
Pack the desiccant and then install the packing, retainer plate.
seat, cap, cover and screws.
Install the drier
Clean the inside of the drier body with
II
clean cloth and then
install the retainer plate and pa<:kirlgs.
Remove the three screws and then remove the drier cover, cap,
seat, retainer plate, and pa(:king.
Remove the desiccant and bake it until it is blue or replace it if
necessary.
3·32