Honda GoldWing GL1100 Service Manual page 243

Install the new pads in the caliper.
1983-
Usa pads which are marked JBCM-GG or A65·FF. When
rapi/acing pads, make sura that al! pads on the motorcycle have
the same mark. Do not mix JBCM·GG and A65- FF marked pads,
Install the pad install one pad pin, then install the other pin
pushing the pads the caliper to depress the pad
retainer over the pad the
in the retainer. Then slide the retainer
to secure the
the pin retainer bolt.
NOTE: Check brake fluid level in the brake master
cylimrjer reservoir this causes the level to rise,
darna~,e
the pads.
positiorled between
bolts to the correct value.
dust on the rear brake,
TORQUE:
Bolts 1982:
Bolt 1983- :
Pivot Bolt 1983- :
M
(l.un1ting
Bolts
1983- : Upper: 40 N·m ft-Ib)
lower: 23 N'm {11
1 11