Table of Contents
Advertisement
Final Drive lubricant
Inspection
With the
on the center stand on a level surface,
remove the oil filler cap. The oil lever should reach the filler hole
threads.
the level is low, add the recommended gear oil
reaches the filler hole threads. Install the filler cap.
until it
With the
on its center stand, put a pan under the
final drive. Remove the filler cap and drain
Rotate the wheel by hand to drain any residual oil.
Fill the gear case with the recommended gear oil. Allow 2·3
minutes for the oil to flow around the gear teeth and
hp.;:lnl~n"
and check
level. Install the filler cap.
Recommended Gear 011: Hypold gear oil API GL·5
Over 5° C,
SAE
90
Below 5° C. SAl: 80
140· 160
cc
(4.7·5.4
Make sure the
install the drain
washer is in
condition and
3.. 19
Advertisement
Table of Contents
Troubleshooting
