Honda GoldWing GL1100 Service Manual page 286

harging
Alternator
driven gear into the starter clutch. Instal! the rotor,
sprocket and chain as an but do not it on all
the
way, leave
about 20 mm
space
between the rotor and
will allow
space
to install the spr'ocket
tab.
Install the sprocket tab and torque it's bolt to 12 N'm (9
install the rear cover and the clutch cover.
Install the generator and check that the pulse air gap is
0.50-0.70 mm
IU ••J<:.l.......u'.V":O
cover.
it bottoms, then torque the rotor
onthe
the stator coils in the rear
Reinstall the
Now,
nut.
16-1