Honda GoldWing GL1100 Service Manual page 175

Final Drive
Seal Removal/Installation
(cont'd)
surfaces.
sealant to the gear case and cover
with mUlltllJUrpo:se grease. Coat the oil seal
Install the gear as:,ernbly,
or fold the oil seal
careful not to darnafle
Fill the
gear retainer oil and dust seals with
mliltil:mrpose NLGI No.2 grease
Place the gear case cover onto the final gear case.
NOTE: After installing the gear case cover, do the follo\l'vinlg:
.. Final gear check 11-1
.. Backlash 11
Insert the gear case cover bolts, the three bolts
with the " -+-" on the photo at the locations shown.
these bolts until the case cover touches
the gear case. Then all bolts in a crisscross
pattern.
8 mm bolts:
10 mm bolts:
26 N'm (19 ft-lb)
40 N'm ft-lb)
11-8