Jeep Wrangler 1997 Manual page 187

Hide thumbs Also See for Wrangler 1997:

Table of Contents

REMOVAL AND INSTALLATION (Continued)

LOWER CONTROL ARM

Fig. 30 Pinion Yoke

Fig. 31 Pinion Yoke Removal

Fig. 29 Ring Gear Bolt Installation

DIFFERENTIAL AND DRIVELINE

(6) Remove the pinion gear from housing (Fig . 32) .

Hold the pinion gear inside axle housing prevent the

gear from falling and being damaged .

Fig. 32 Remove Pinion Gear

SPECIAL TOOL

Remove the pinion gear seal, slinger, and outer

bearing with Remover 7794-A and Slide Hammer

7420 (Fig . 33) .

Fig. 33 Remove Pinion Seal, Slinger, and Outer

(8) Remove oil slinger, front bearing.

(9) Remove the outer pinion bearing cup and seal

with Remover D-147 and Handle C-4171 (Fig. 34) .

(10) Remove the inner bearing cup from housing

(Fig . 35) . Use Remover D-148 and Handle C-4171 .

NOTE : The pinion gear depth shims are located

behind the inner pinion bearing cup.

Troubleshooting