Front Fog Lamp (Trailhawk); Rear Turn Signal Lamp; Back-Up Lamp - Jeep 2015 Cherokee Operating Information Manual

CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
5. Install the bulb and socket assembly into the
into the fog lamp housing, and rotate the
connector clockwise to lock it in place.
6. Install the 3 hex head screws into the wheel
liner.

Front Fog Lamp (Trailhawk)

1. Unlock lower access door in wheel liner.
2. Reach behind the fog lamp housing to ac-
cess the bulb.
3. Squeeze the two tabs on the side of the bulb
socket and pull straight out from the fog
lamp.
4. Disconnect the wire harness from the bulb.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
5. Reconnect the wiring harness to the new
bulb and reinstall by inserting the new bulb
straight into the fog lamp housing until it
locks in place.
6. Lock the lower door in the wheel liner.

Rear Turn Signal Lamp

1. Open the liftgate.
2. Remove the screws that fasten the tail lamp
housing to the vehicle.
3. Grasp the tail lamp and pull firmly rearward
to disengage the lamp from the vehicle.
4. Disconnect the electrical connector.
5. Twist the socket counterclockwise and re-
move from housing.
6. Pull the bulb to remove it from the socket.
7. Replace the bulb and install the socket.
8. Reconnect the electrical connector.
9. Reinstall the tail lamp housing and screws.
10. Close the liftgate.

Back-up Lamp

1. Open the liftgate.
2. Use a fiber stick or flat blade screw driver to
pry the lower trim from the liftgate.
3. Once the trim is loose, pull it back exposing
the trim panel.
4. Using a fiber stick or flat blade screw driver,
open the trim panel exposing the back of the
liftgate lamp.
393