Setting The Scan Resume Technique; To Set The Scan-Resume Mode - Yaesu VX-150 Operating Manual

Scanning
The VX-150 allows you to scan just the memory channels, the operating band, or a portion
of that band. It will halt on signals encountered, so you can talk to the station(s) on that
frequency, if you like.
Scanning operation is basically the same in each of the above modes. Before you begin,
take a moment to select the way in which you would like the scanner to resume scanning
after it halts on a signal.

Setting the Scan Resume Technique

Three options for the Scan-Resume mode are available:
5 SEC 5 SEC
5 SEC 5 SEC: In this mode, the scanner will halt on a signal it encounters, and will hold there for 5 SEC
5 seconds. If you do not take action to disable the scanner within that time period,
the scanner will resume even if the stations are still active.
BUSY BUSY
BUSY BUSY: In this mode, the scanner will halt on a signal it encounters. Two seconds after the BUSY
carrier has dropped because the other station(s) ceased transmission, the scanner
will resume. In the case of constant-carrier signals like Weather Station broad-
casts, the scanner will likely remain on this frequency indefinitely.
HOLD HOLD
HOLD HOLD: In this mode, the scanner will halt on a signal it encounters. It will not restart HOLD
automatically; you must manually re-initiate scanning if you wish to resume.

To set the Scan-Resume mode

•
Press the [ F/W ] key, then press the [ 0 ( SET ) ] key, to enter the Set mode.
‚
Rotate the DIAL to select Menu #7 ("RESUME
ƒ
Press the [ F/W ] key to enable changing of this Menu item.
„
Rotate the DIAL to select the desired scan-resume mode.
...
When you have made your selection, press the PTT key to save the new setting and exit
to normal operation.
The default condition for this Menu Item is "5 SEC".
34
RESUME"). RESUME RESUME
RESUME
VX-150 O M
PERATING ANUAL