Set (Menu) Mode - Yaesu FT-25E Operating Manual

Set (Menu) Mode

The FT-25R/E Set Mode, already partially described in the previous chap-
ters, may be activated to select or change various transceiver functions.
Many of the useful parameter configurations have not been fully detailed in
this manual. Refer to the chart below for a list of the Set Mode Items and
their various parameters.
1. Press and hold the F key to enter the Set Mode.
2. Press the [▲] or [▼] key to select the Set Mode Item to be adjusted.
3. Press the F key momentarily to enable adjustment of the Set Mode Item.
4. Press the [▲] or [▼] key to adjust or select the parameter to be changed
on the Set Mode Item selected in above step.
5. After completing your selection and adjustment, press the PTT switch mo-
mentarily to save the new setting and exit to normal operation.
Press and hold the F key to move from the lower menu con-
tents to the upper menu contents in the Set Mode.
Item
(lower menu
item)
1 APO Setting of the Automatic
Power-Off feature.
2 ARTS Selects the Beep
option and the Polling
Interval during ARTS
operation.
3 BATTSAVE Selects the Receive-
mode Battery Saver
interval ("sleep" ratio)
4 B-CH.L/O
Enables/Disables the
Busy Channel Lock-
Out feature.
5 BEEP Beep function Enable/
Disable on presssing
the keypad, or stopping
the receiver scanning.
6 BELL Select the number of
CTCSS/DCS/PAGER/
ARTS Bell ringer
repetitions.
7 COMPANDE Enables/Disables the
(COMPANDER) Voice Compander
feature
40
Function
OFF / 0.5H to 12.0H
(Step 0.5H)
BEEP= INRANG /
ALWAYS / OFF
INTV= 25SEC / 15SEC
200mS / 300mS / 500mS
/ 1SEC / 2SEC / OFF
OFF / ON
KEY+SC / KEY / OFF
OFF / 1Time / 3Times/
5Times / 8Times /
CONTINUE
OFF / ON
FT-25R/FT-25E Operating Manual
Values Default Value
OFF
BEEP=OFF
INTV= 25SEC
200mS
OFF
KEY+SC
OFF
OFF