Motorola MVME2300 Series Programmer's Reference Manual page 104

Raven PCI Bridge ASIC
2
2-34
FLBRD Flush Before Read. If set, the Raven will guarantee that
all PCI-initiated posted write transactions will complete
before any MPC-initiated read transactions are allowed to
complete. When FLBRD is clear, there is no correlation
between these transaction types and their order of
completion. Please refer to the
section for more information.
BHOG Bus Hog. If set, the Raven MPC master will operate in the
Bus Hog mode. Bus Hog mode means the MPC master
will continually request the MPC bus for the entire
duration of each PCI transfer. If Bus Hog is not enabled,
the MPC master will request the bus in a normal manner.
Please refer to the
information.
MBTx MPC Bus Time-out. Specifies the MPC bus time-out
length. The time-out length is encoded as follows:
P64 64-bit PCI Mode Enable. If set, the Raven is connected
to a 64-bit PCI bus. This bit is set if REQ64 is asserted
on the rising edge of RESET .
MARB MPC Arbiter Enable. If set, the Raven internal MPC
Arbiter is enabled. This bit is set if CPUID is %111 on the
rising edge of RESET .
MPIC Multi-Processor Interrupt Controller Enable. If set,
the Raven internal MPIC interrupt controller is enabled.
This bit is set if EXT15 is high on the rising edge of
RESET . If cleared, Raven-detected errors are passed on
to the processor 0 INT pin.
Transaction Ordering
MPC Master section for more
MBT Time-Out Length
00 256 sec
01 64 sec
10 8 sec
11 Disabled
Computer Group Literature Center Web Site