Table of Contents
Advertisement
Programming Notes
This section includes a number of items of information that should prove
helpful in programming your MVME2300 series board for a variety of
applications.
External Interrupt Service
The following summarizes how an external interrupt is serviced:
1. An external interrupt occurs.
2. The processor state is saved in the machine status save/restore
3. The external interrupt handler calculates the address of the Interrupt
4. The external interrupt handler issues an Interrupt Acknowledge
5. The interrupt handler saves the processor state and other interrupt-
http://www.motorola.com/computer/literature
processing for the highest-priority interrupt currently in
service by the associated processor. The write operation
will update the In-Service register by retiring the highest-
priority interrupt. Reading this register returns zeros.
registers. A new value is loaded into the Machine State register
(MSR). The External Interrupt Enable bit in the new MSR (MSRee)
is set to zero. Control is transferred to the O/S external interrupt
handler.
Acknowledge register for this processor (RavenMPIC Base Address
+ 0x200A00 + (processor ID shifted left 12 bits)).
request to read the interrupt vector from the RavenMPIC. If the
interrupt vector indicates the interrupt source is the 8259, the
interrupt handler issues a second Interrupt Acknowledge request to
read the interrupt vector from the 8259. The RavenMPIC does not
interact with the vector fetch from the 8259.
specific information in system memory and re-enables for external
interrupts (the MSRee bit is set to 1). The RavenMPIC blocks
interrupts from sources with equal or lower priority until an End-of-
Interrupt is received for that interrupt source. Interrupts from
higher-priority interrupt sources continue to be enabled. If the
Raven Interrupt Controller
2-87
2
Advertisement
Table of Contents
