Operation; Check Points Before Operation; Check Points For Preset And Pattern Function Before Operation - LEGRAND 4 305 21 User Manual

3 Operation

3.1 Check Points before Operation


Before turning on the system, check if the wire(s) and cable(s) are connected properly.

Check if the camera ID on the controller is properly selected. The camera ID must be identical to that of the target
camera. The camera ID can be checked by reading the DIP switch of the camera or on OSD.

If your controller supports multi-protocols, the protocol must be changed to match to that of the camera.

Adjust the DIP switch after turning off the camera. If you changed the camera protocol by changing the DIP S/W, the
change will be effective after you reboot the camera.

Since the operation method can be different by controllers, refer to your controller manual if the camera can not be
controlled properly. The operation of this manual is based on the standard Pelco® Controller.

3.2 Check Points for Preset and Pattern Function before Operation


Check fully how to operate preset function and pattern function with your controller or DVR in advance to operate the
camera functions when using a controller or a DVR.

Refer to the following table when using standard Pelco® protocol controllers.
< Go Preset >
< Set Preset >
< Run Pattern >
< Set Pattern >

If your controller or DVR has no pattern button or function, use the Hot Keys with preset numbers. For more information,
refer to "Reserved Presets(Hot Keys)" in this manual.
Input [Preset Number] and press [Preset] button shortly.
Input [Preset Number] and keep pressing [Preset] button for more than 2 seconds.
Input [Pattern Number] and press [Pattern] button shortly.
Input [Pattern Number] and keep pressing [Pattern] button for more than 2 seconds.
32