Direct Installation On The Ceiling (4 305 22 Model) - LEGRAND 4 305 21 User Manual

2.4 Direct Installation on the Ceiling (

Direct Installation on the Ceiling (4 305 22 model)

①
To pass cables to upside of ceiling, please, To pass cables to upside of ceiling, please,
make about 50~60mm hole on the ceiling make about 50~60mm hole on the ceiling panel.
③
After assembling the Rubber Gasket to After assembling the Rubber Gasket to
the Terminal Cover, install Terminal Cover on the Terminal Cover, install Terminal Cover on
ceiling tex and connect cables to terminal blocks. ceiling tex and connect cables to terminal blocks.
⑤
Check the 2 mold line for assembly before Check the 2 mold line for assembly before
starting assembly. Line up the mold lines as shown starting assembly. Line up the mold lines as shown
in the dotted circle and turn main body on its axis in the dotted circle and turn main body on its axis
in CW(Clock-Wise) direction and assemble Wise) direction and assemble main
body to Terminal Cover.
②
For cable connection, remove the pre cable connection, remove the pre-defined hole mark on
the Rubber Gasket and locate the summit of the Plate Spring at the and locate the summit of the Plate Spring at the
arrow mark as shown in the dotted circle. arrow mark as shown in the dotted circle.
④
Connect the "Drop Prevention Spring
prevent camera from drop.
⑥
Tighten the Lockup Screw as shown bellow. Tighten the Lockup Screw as shown bellow.
21
evention Spring" to the main body to