Parking Action Setup; Alarm Input Setup - LEGRAND 4 305 21 User Manual

Parking Action Setup

This feature allows the camera to begin a specified action after a programmed time of inactivity. This feature allows the camera to begin a specified action after a
 Park Enable
 Wait Time
 Park Action

Alarm Input Setup

Defines Alarm Function. When an alarm is receive, an input signal to the camera triggers the user-defined action programmed Defines Alarm Function. When an alarm is receive, an input signal to the camera triggers the user Defines Alarm Function. When an alarm is receive, an input signal to the camera triggers the user
for the alarm.
 Alarm No
 Type
 Action
[ON/OFF]
If Park Enable is set to ON, the camera runs an If Park Enable is set to ON, the camera runs an assigned function automatically if there is no PTZ
command during the programmed "Wait Time". command during the programmed "Wait Time".
[1~59 sec. / 1~180 min.] [1~59 sec. / 1~180 min.]
Wait Time can be programmed from 1 second to 180 minutes. Wait Time can be programmed from 1 second to 180 minutes.
[HOME/PRESET/PATTERN/SWING/GROUP/PREV ACTION] [HOME/PRESET/PATTERN/SWING/GROUP/PREV ACTION]
This feature defines the activity when the camera parks. If Park Action is set to "HOME", the camera This feature defines the activity when the camera parks. If Park Action is set to This feature defines the activity when the camera parks. If Park Action is set to
moves to the home position which is memorized when the system boots. If Park Action is set to moves to the home position which is memorized when the system boots. If Park Action is set to moves to the home position which is memorized when the system boots. If Park Action is set to
"PREV. ACTION", the camera runs the previous action which it , the camera runs the previous action which it ran most recently.
[1~3]
Selects a sensor number to set up. Selects a sensor number to set up.
[Normal OPEN/Normal CLOSE] OPEN/Normal CLOSE]
Selects sensor operation type. Selects sensor operation type.
[NOT USED/PRESET/PATTERN/SWING/GROUP] [NOT USED/PRESET/PATTERN/SWING/GROUP]
Selects an action to run when a sensor signal is input. Selects an action to run when a sensor signal is input.
time of inactivity.
assigned function automatically if there is no PTZ
ran most recently.
48