Configuring Your Library; About The Setup Wizard; Using The Default Administrative User Account - Quantum Scalar i500 User Manual

Once you have installed the hardware as described in the Getting Started Guide, you are ready to configure
your library's settings. A Setup Wizard helps you get started configuring your library, and menu commands
on both the operator panel and the web client allow you to reconfigure your library at any time.
Always save the library configuration after modifying configurable items.
CAUTION
This will allow you to restore the most current settings if necessary. See
About Saving and Restoring the Configuration

About the Setup Wizard

When you first power on the library, the operator panel displays the Setup Wizard, which walks you through
the initial configuration of the library's basic operational settings, including network settings that enable you
to access the library from the web client.
You must begin the Setup Wizard on the operator panel, but you have the option to complete the Setup
Wizard on the web client. The Setup Wizard prompts you to enter the network settings that allow the web
client to access the library. Once this step is complete, you must choose to either complete the wizard locally
(on the operator panel) or remotely (on the web client). The on-screen instructions recommend that you
choose to complete the wizard on the web client. The web client Setup Wizard offers more options.
While completing the Setup Wizard remotely is recommended, you may need to begin using the library
locally immediately. In this case, you can complete the Setup Wizard on the operator panel or even cancel
out of the Setup Wizard and allow the library to run on the default configuration settings.
Administrative users can always return to the Setup Wizard or use commands on the Setup and Operations
tabs to modify all library settings, including network settings.
For additional information, see

Using the Default Administrative User Account

When you power on the library for the first time, you do not need to log in to use the operator panel. You
can start using the Setup Wizard immediately. After the initial setup session on the operator panel, however,
you will need to log in to the operator panel as well as the web client.
Scalar i500 User's Guide

Configuring Your Library

Using the Setup Wizard
on page 208.
on page 32.
31