Getting Information; Viewing System Information; Viewing The Library Configuration - Quantum Scalar i500 User Manual

The About screen on the operator panel gives you a quick glance at your library settings. You can view
more information about the library by accessing items under the Reports menu. The Reports menu is
available only on the web client.
Users without administrative privileges can view only certain reports. See
Note
Understanding the User Interface
privileges.

Viewing System Information

The System Information report contains information on the following library settings:
• Date and time — current date, time, and time zone settings
• Physical library — host name, Internet Protocol (IP) address, serial number, and firmware version
of the physical library, board support package (BSP) version, and the date the BSP was last
updated.
• Library Partitions — name, serial number, control path, status, slots, media, and tape drives
• Tape drives — location coordinates, vendor name, model, type, physical serial number (P-SN),
logical serial number (L-SN), firmware level, sled boot version, sled application version, and
whether the tape drive is connected to an I/O blade
The path to open the report from the web client is Reports > System Information.

Viewing the Library Configuration

The Library Configuration report is a dynamic representation of the physical locations of various library
resources, including tape drives, slots, partitions, and modules. Use the report to view information on the
following resources:
• Tape drives — including the interface (FC, SCSI, or SAS), cartridge type, mode status, assigned
partition, location coordinates, barcode, element address, vendor, model, physical serial number
(SN), logical SN, World Wide Node Name (WWNN), World Wide Port Name (WWPN), topology
request, speed request, topology actual, speed actual, SCSI or loop ID, firmware level, and control
path setting of each tape drive
Scalar i500 User's Guide

Getting Information

on page 23 for information about user
91