Preparing To Use The Library - Quantum Scalar i500 User Manual

c. From the back of the library, find the rear Y-rail release mechanism, which is located in the
interior of the right side of the module. Squeeze the handle of the Y-rail release mechanism, lift
it out of its locked position, and slide it downward as far as it will go.
Doing this aligns the Y-rails with the Y-rails of the module beneath it.
CAUTION
1 Y-rail in unlocked, functional
position
9 Repeat these steps for each module you need to re-install in the library configuration.

Preparing to Use the Library

1 Add the tape drives to the modules. For details, see
page 193.
2
Add the power supplies. For details, see
page 179.
3 Add the LCB to the control module. For details, see
and LCB Compact Flash Card
144 Installing, Removing, and Replacing
Check to make sure that there is no gap between the top and bottom
Y-rails on both the front and back of the library. If a gap exists, the
library cannot mechanically initialize.
Adding, Removing, and Replacing Power Supplies
on page 176.
1
Adding, Removing, and Replacing Tape Drives
Removing and Replacing the Library Control Blade
on
on