Remote Configuration; Managing The Network; Modifying Network Settings - Quantum Scalar i500 User Manual

The network configuration settings are the only settings that must be configured using the operator panel.
Once the IP address is set, you can access the Setup Wizard from the web client and configure the
remaining settings.

Remote Configuration

The Setup Wizard: Remote Configuration screen provides the information necessary to access the web
client to complete the initial configuration of the library.
The screen lists the IP address of the library. Use this IP address to access the web client using a Web
browser. When typing the IP address into the Web browser, make sure to precede it with http://; for example,
http://123.123.123.123.

Managing the Network

Administrative users can configure the following:
• Network settings that allow remote access to the library. For more information, see
Network Settings
• Secure Socket Layer (SSL) settings that increase data protection so that data from the library can
be sent over the internet securely. For more information, see
• Simple Network Management Protocol (SNMP) settings that allow you to use an external
management application to monitor the status of the library. For more information, see
SNMP Settings on the Library
Security settings must be enabled to allow SNMP, SMI-S, and IP address
CAUTION
access to the library network. After applying any of the settings on the
Network Management screens, verify the settings on the Security Settings
screen. See

Modifying Network Settings

The Setup Wizard: Network Configuration screen allows administrative users to configure network settings
that allow remote access to the library from the web client. After the initial configuration, you can modify the
network settings from either the operator panel or the web client.
From the web client, you can use the Setup - Network screen to modify the following network settings: library
name, Dynamic Host Configuration Protocol (DHCP) enable/disable, IP address, subnet mask, default
gateway address, and primary and secondary Domain Name Service (DNS) addresses.
From the operator panel, you can use the Network Configuration screen to modify the following network
settings: library name, DHCP enable/disable, IP address, subnet mask, and default gateway.
In addition, when DHCP is disabled on the Network Configuration screen, you can use the DNS Settings
screen to configure the primary and secondary DNS server addresses. DNS servers provide IP address
resolution of fully qualified domain names. DNS settings are optional.
If you modify the IP address, you will need to type the new IP address in the Address field of your Web
browser to access the web client.
Scalar i500 User's Guide
on page 35.
on page 37.
Configuring Library Security Settings
Modifying
Enabling SSL on page 37.
on page 71.
Configuring
35