Figure 22 Multi-Module Sas Cabling - Quantum Scalar i500 User Manual

Figure 22 Multi-Module SAS Cabling
9
1 module-to-module cable
2
library control blade
3 GB Ethernet port
4 power supply
5 rear power switch
1 If your library is 14U or larger, install it in a rack. See
instructions. The instructions include procedures for removing and replacing tape drives.
2
Connect one end of the SAS cable to the tape drive. Connect the other end of the SAS cable to the host.
3 If your library configuration consists of a single module, place module terminators in the module's top
and bottom module terminator connectors.
CAUTION
4 If the library consists of more than one module, connect the modules together as follows:
CAUTION
116 Installing, Removing, and Replacing
2
1
8
The module terminator is not the same as a SCSI terminator. Using a
SCSI terminator instead of a module terminator will damage the
library.
The module terminator is not the same as a SCSI terminator. Using a
SCSI terminator instead of a module terminator will damage the
library.
3
4
4
7
6 power cords
7
SAS cables to host
8 module terminators
9 Ethernet cable to customer
network
Installing the Rackmount Kit
5
6
on page 181 for