Configuring The Library; Verifying The Scsi Settings; Table 2 Scsi Id Default Settings - Quantum PowerStor L200 Series User Manual

Configuring the Library

Table 2 SCSI ID
Default Settings
Verifying the SCSI
2
Settings
If all the POST tests are completed successfully, and the drive and
library are initialized, the library is ready for operation. If the tests
did not complete, run the POST again; if the tests are still not
complete, the library needs service.
Note: To rerun the POST, turn off the library. Wait ten seconds,
then turn the library power on again.
Configuration consists of verifying that the library and the internal
drive have the correct SCSI ID settings. The system uses SCSI IDs
to identify or address devices, such as the library controller and the
tape drive on the SCSI bus.
If the library is one of multiple SCSI devices on the bus, be sure to
use a SCSI ID that is unique from any other device or system ID on
the SCSI bus (see
SCSI ID Device
1 Tape drive
0 Library controller
To view the current SCSI ID settings using the OCP (see
Press Select until the message SCSI ID? is displayed.
1
Press Next to enter the SCSI ID menu and display the message
2
View ID?.
Press Enter to view all the SCSI IDs.
3
Quantum|ATL PowerStor L200 Series Library User's Guide
table 2).
Chapter 2 Installing the Library
Configuring the Library
figure
2
1):
19