Reassembly And Remounting - Suzuki GZ250 Service Manual

REASSEMBLY AND REMOUNTING

Reassemble and remount the swingarm and rear shock
absorber in the reverse order of removal and disassembly.
Pay attention to the following points: • Press the needle
bearings into the swingarm pivot using a suitable
socket and the special tool. (See p. 5-36.)
09924-84521: Bearing installer set
NOTE:
Install the needle bearings with the stamped mark facing
out.
• Apply grease to the spacers, dust seals and needle
bearings.
99000-25010: SUZUKI SUPER GREASE "A"
• Install the rear torque link
• Tighten the rear torque link nut to the specified torque.
Rear torque link nut: 13 N-m (1.3 kg-m, 9.5 Ib-ft)
• Install the new cotter pin.
• Install the swingarm and tighten the swingarm pivot nut
to the specified torque.
Swingarm pivot nut: 72 N■ m (7.2 kg-m, 52.0 Ib-ft)
to the swingarm.
CHASSIS 5-40