Suzuki GZ250 Service Manual page 93

• Install the clutch sleeve hub and lock washer.
• Install the clutch sleeve hub nut, and tighten it to the
specified torque using the special tool.
09920-53740: Clutch sleeve hub holder
Clutch sleeve hub nut: 50 N-m (5.0 kg-m, 36.0 Ib-ft)
• Bend the lock washer securely.
• Install the washer seat
shown.
• Install the clutch drive plate No.2
• Install the clutch drive plates No.1
one by one into the clutch sleeve hub.
• Install the clutch push rod
• Install the push piece , bearing and washer
• Install the clutch pressure plate
clutch spring mounting bolts.
• Hold the generator rotor using the special tool and tight-
en the clutch spring mounting bolts to the specified
torque in a crisscross pattern.
09930-44913: Rotor holder
Clutch spring mounting bolt:
10N-m(1.0kg-m, 7.0 Ib-ft)
NOTE:
Make sure that the clutch pressure plate is installed cor-
rectly.
• Loosen the lock nut , and turn in the release screw
to feel resistance.
• From that position, turn out the release screw
and tighten the lock nut
and spring washer
and driven plates
, clutch springs and
by holding the release screw
as
turn,
ENGINE 3-56