Starter Plunger Cable Play; Clutch; Engine Oil And Oil Filter - Suzuki GZ250 Service Manual

Hide thumbs Also See for GZ250:
Table of Contents

Advertisement

2-9 PERIODIC MA INTENA NCE

STARTER PLUNGER CABLE PLAY

Starter plunger cable play
(0.02-0.04 in) as shown. If the play
it as follows:
• Loosen the lock nut
until the specified play is obtained.
• Tighten the lock nut
Starter plunger cable play

CLUTCH

Inspect every 5 000 km (3 000 miles, 15 months).
• Loosen the lock nut and turn the adjuster
• Loosen the lock nut and turn the adjuster
clutch lever play
Clutch lever play : 10-15 mm (0.4-0.6 in)
• Tighten the lock nuts

ENGINE OIL AND OIL FILTER

(ENGINE OIL)
Replace initially at 1 000 km (600 miles, 3 months)
and every 5 000 km (3 000 miles, 15 months) there-
after.
(OIL FILTER)
Replace initially at 1 000 km (600 miles, 3 months)
and every 10 000 km (6 000 miles, 30 months)
thereafter.
The engine oil should be changed while the engine is
warm. Oil filter replacement at the above intervals should
be done together with the engine oil change.
ENGINE OIL REPLACEMENT
• Keep the motorcycle upright.
• Place an oil pan below the engine, and drain the engine
oil by removing the engine oil drain plug
cap .
• Tighten the oil drain plug
pour new oil through the oil filler. When performing an oil
change (without oil filter replacement), the engine will
hold about 1 300 ml (1.4/1.1 US/Imp qt) of oil. Use SF or
SG classified (API) engine oil with a viscosity rating of
10W-40 (SAE).
Oil drain plug: 28 N-m (2.8 kg-m, 20.0 Ib-ft)
• Install the oil filler cap
should be 0.5-1.0 mm
is incorrect, adjust
and turn the adjuster in or out
while holding the adjuster
0.5-1.0 mm
(0.02-0.04 in)
is within specification.
to the specified torque, and
fully in.
until the
and oil filler

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents