CPI GTR180 Service Manual page 92

CPI MOTOR GTR180
IX.DRIVE AND DRIVEN PULLEYS & KICK STARTER
Install the cir-clip to driven plate comp.
Installing pin.
Change drive face bearing
Remove the inner bearing
ATTENTION!!!
There is an oil seal at one side of inner bearing in drive
face, dismantle the oil seal firstly.
For needle bearing, disassemble the c-clip first then for
bearing.
Install the new bearing, the seal side should towards
to outside.
Apply the required grease.
Install the cir-clip to install the bearing.
Install the new inner bearing
Assembly of clutch / drive face assy.
Install the new oil seal & o-ring on movable driven
face assy.
《9 -18 》