CPI GTR180 Service Manual page 64

CPI MOTOR
VIII.CARBURETOR REMOVAL
SERVICE INFORMATION
GENERAL INSTRUCTIONS
When working with gasoline, keep away from sparks and flames.
Note the locations of O-rings when disassembling and replace them with new ones during
assembly.
Before float chamber disassembly, drain the residual gasoline from the float chamber.
Do not try to disassemble the auto bystarter.
When assembling the vacuum chamber and air cut-off valve, be careful not to damage the
diaphragms.
All cables, fuel lines and wires must be routed and secured at correct locations.
When removing the fuel tank, keep sparks and flames away from the working area.
When removing the fuel tank, the remaining fuel in the tank must be lower than _ of the fuel tank
capacity to avoid gasoline overflowing.
Fuel tank capacity: 10.5 liters
Identification number
Venturi dia(mm)
Float level (mm)
Pilot screw opening
Fuel pump output
Main jet
Slow jet
Idle speed
17L/H1r6/700000rpm
《 8-2 》
GTR180
KEIHIN 017
23 mm
18 mm
2 1/4
#108
#17.5
1800±100