CPI GTR180 Service Manual page 59

CPI MOTOR GTR180
VII.CYLINDER HEAD & CAM SHAFT REMOVAL
Install the intake pipe comp.
Install:
1.Flange bolts. [A]
Install thermostat comp.
ATTENTION
Please check the thermostat comp. oil seal is damaged or
broken, if yes, replaced a new one.
ASSEMBLE THE CAM SHAFT HOLDER.
First install the intake and exhaust valve rocker arms; then
install the rocker arm shafts.
Install dowel pins to cylinder head assy.
NOTE
Clean the intake valve rocker arm shaft off any grease
before installation.
Align the cutout on the exhaust valve rocker arm shaft
with the bolt of the camshaft holder
Install washers and nuts.
Install:
1.Washers and nuts. [A]
《 7-13 》