CPI GTR180 Service Manual page 85

CPI MOTOR GTR180
IX.DRIVE AND DRIVEN PULLEYS & KICK STARTER
Remove drive belt.
Using the multi-Installing(Y shape Installed tool) clip to
install the driven face, disassemble the nut, washer ad drive
face.
Using the multi-Installing clip (Y shape Installing tool) to
install the driven pulley outer then remove the nut and
driven pulley outer.
DRIVEN BELT INSPECT
Put drive belt into driven pulley groove (same as the picture)
make ir loosen,then take out belt and driven pulley together.
Disassamble the belt from groove.
Inspect the belt for crack wear damage.
Measure the width of belt
SERVICE LIMIT : 20.7mm
《9 -11 》