CPI GTR180 Service Manual page 60

CPI MOTOR GTR180
VII.CYLINDER HEAD & CAM SHAFT REMOVAL
Turn the A.C. generator flywheel so that the "I" mark on
the flywheel aligns with the index mark on the crankcase.
Make sure two parallel lines on cam shaft chain wheel are
paralleled with cylinder head surface. Meanwhile, make
sure the position is at the top dead center of the
compression stroke.
Install the oil plug , oil plug spring.
Install the tension device.
CHECK
Before assembly, the tensioner device must check if the
tension device gasket is broken.
Before assembly, the tensioner device is pressed to the
top.
Install the screw.
CHECK
Make sure to put tensioner lifter spring and o-ring into
tensioner.
《 7-14 》