CPI GTR180 Service Manual page 86

CPI MOTOR GTR180
IX.DRIVE AND DRIVEN PULLEYS & KICK STARTER
INSTALL DRIVEN ASSY.
Put apart the drive pulley, then install the drive belt into the
drive pulley.
Install the driven pulley assy. with drive belt to the drive
shaft. Assemble another side of drive belt to movable drive
face.
I
nstall the driven pulley assy. outer.
Using the multi-Installing tool("Y" shape tool) to install the
driven pulley assy. outer and tighten the nut by standard
torque.
Torque：5.0~6.0kgf-m
Install the movable drive face, washer & nut.
Using the multi-Installing tool ("Y" shape tool) to install
the drive face.
PAY ATTENTION!!!
It must be no any grease on both sides of drive face, use
grease stripper to clean the unnecessary grease.
Torque：5.0~6.0kgf-m
《9 -12 》