CPI GTR180 Service Manual page 110

CPI MOTOR
X.ELECTRIC SYSTEM
Ignition Coil
Dismantle
Remove protected net 1.2、under cover
Remove spark cover
Remove ignition coil – Leading wire "A"。
Remove the bolt of ignition coil, take out the coil.
Installation will be used opposite procedure of dismantling.
ATTENTION!!!
Once coil is black wire to connect the black connector,
pink wire connect the green connector.
Spark Plug confirmation
Remove spark plug as the right drawing, install good
spark on the spark cap and match the engine starting
situation to make sure if the spark plug to have normal
function. If the ignition situation is no good or the
spark plus have been burned, please change a new spark
plug.
ATTNENTION!!!
Each electric circuit need to match the proper connection
and test. It'll have no good testing sometime even
have the proper connection.
Connect the high pressure Shunt ("A") on the electric
meter or use the meter with input impedance of Ω 100V
up. Remove the middle cover.
Connect the meter cable with once coil terminal (black
wire and pink wire). Push the starter button or step on
the starter lever, test the maximum electric voltage of
ignition coil.
Connection：(+) terminal connect green (–) terminal
connect black/yellow.
《 10-16 》
GTR180